Start Demo

Integrate Reveal(x) 360 with Netskope

This integration enables you to configure ExtraHop sensors to ingest packets from your Netskope solution to detect threats, discover and monitor devices, and gain insight into traffic.

Enable Netskope packet ingest

You can enable Netskope packet ingest on one or more sensors on the ExtraHop system.

Before you begin

  • Your Reveal(x) system must be connected to an ExtraHop sensor with firmware version 9.4 or later.
  • Your ExtraHop sensor must be dedicated to ingesting Netskope packets only.
  • You must configure at least one interface on your ExtraHop sensor; all interfaces must specify a mode that includes GENEVE encapsulation.
  1. Log in to the Administration settings on the sensor through https://<extrahop-hostname-or-IP-address>/admin.
  2. From the Network Settings section, click Connectivity.
  3. From the Netskope Settings section, select Enable Netskope packet ingest.
  4. Click Save.

Next steps

Check the status of sensors integrated with Netskope

From the Reveal(x) 360 console, you can view the status of sensors enabled for Netskope packet ingest.

  1. Log in to Reveal(x) 360.
  2. Click the System Settings icon and then click Integrations.
  3. Click the Netskope tile.
    The Netskope integration page displays the following information:
    • The number and names of connected sensors that are configured to ingest Netskope packets.
    • Whether a sensor is online or offline.
    • The timestamp of the last packet received.
  4. (Optional): Click Go to Sensors to view configuration details for individual sensors, enable or disable sensors, or upgrade sensor firmware.
Last modified 2024-09-16