ExtraHop bundles enable you to add pre-configured customizations to the ExtraHop
system.
Before you begin
You must have a bundle JSON file. You can download a bundle
from the ExtraHop system by navigating to , selecting the bundle, and then clicking
Download
Bundle from the right pane.
After you have downloaded a bundle, you can upload and
install the bundle on your system.
-
Log in to the ExtraHop system through
https://<extrahop-hostname-or-IP-address>.
-
Click the System Settings icon
.
-
Click Bundles.
-
Click Upload Bundle.
-
In the Upload Bundle pane, click Choose
File, and then select the bundle JSON file you want to
upload.
Details about the bundle content appear, including the minimum required
firmware version.
-
In the Install Options section, select the following checkboxes:
-
(Command appliances and Reveal(x) 360 only) Select the site where you
want to install the bundle.
| Note: | Bundle customizations such as alerts and triggers are added to the
selected sites. However, you can only view, enable, and configure
customizations from the ExtraHop system where the bundle was
installed. |
-
Select the Apply included assignments
checkbox.
This option assigns the bundle to the metric sources included with the
bundle. In most cases, it is best to apply the default
assignments.
-
Select the Overwrite existing content
checkbox.
This option overwrites any objects that have the same name as objects
in the bundle. If you have existing system objects with the same name
that you want to preserve, you must rename those objects to avoid
overwriting them with the objects in the bundle.
-
Click Install.
Next steps
- Enable any triggers included
in the bundle.
- Configure any alerts in the
bundle to notify relevant email addresses.
Thank you for your feedback. Can we contact you to ask follow up questions?