After you deploy an Explore appliance, you must establish a connection from all
ExtraHop Discover and Command appliances to the Explore appliance before you can query for
stored records.
Important: | If you have an Explore cluster of three or more Explore nodes,
connect the Discover appliance to each Explore node so that the Discover appliance
can distribute the workload across the entire Explore cluster. |
Note: | If the Explore appliance connections are managed from a Command appliance, you
must perform this procedure from the Command appliance instead of from each Discover
appliance. |
-
Log into the Admin UI of the Discover or Command appliance.
-
In the ExtraHop Explore Settings section, click
Connect Explore Appliances.
-
Click Add New.
-
In the Explore node field, type the hostname or IP address
of any Explore appliance in the Explore cluster.
-
For each additional Explore appliance in the cluster, click Add
New and enter the individual hostname or IP address in the
corresponding Explore node field.
-
Click Save.
-
Confirm that the fingerprint on this page matches the fingerprint of Node 1 of
the Explore cluster.
-
In the Explore Setup Password field, type the password for
the Explore Node 1 setup user account and then click
Connect.
-
When the Explore cluster settings are saved, click
Done.
Next steps
Important: | If you only deployed a single Explore appliance, after you
connect to your Discover or Command appliance, you must log into the Admin UI on the
Explore appliance and set the to 0. |
Thank you for your feedback. Can we contact you to ask follow up questions?