Start Demo

Set up shared SNMP credentials for your NetFlow or sFlow networks

If you enable SNMP polling on your flow network configuration, you must specify the credentials that allow you to poll the network device. The SNMP authentication credentials apply to all flow networks in a CIDR block and are automatically applied to every discovered flow network unless custom credentials are configured.

  1. Log into the Admin UI on your Discover appliance.
  2. In the Network Settings section, click Flow Networks.
  3. In the Shared SNMP Credentials section, click Add SNMP Credentials.
  4. Type the IPv4 CIDR block in the CIDR field.
  5. Select v1, v2c, or v3 from the SNMP version drop-down list and then complete the remaining fields.
  6. Click Save.

Manually refresh SNMP information

You can poll and retrieve data on demand from the SNMP agent on a flow network device. Instead of waiting for automatic polling to occur after each configuration change to confirm that the change is correct (automatic polling occurs every 24 hours), you can poll immediately.
  1. Log into the Admin UI on your Discover appliance.
  2. In the Actions column for the approved flow network, click Poll.
    The ExtraHop system polls for the following information:
    • The system name of the SNMP agent. This identifier is assigned by SNMP to the flow network.
    • The interface name of each interface on the SNMP agent. These identifiers are for each flow interface on the flow network.
    • The interface speed of each interface on the SNMP agent.
Published 2020-01-22 20:52