Install the SSL Decryption Board

  1. Remove the Extrahop Appliance from the Data center rack.

  2. Open the top cover by rotating the locking clasp to the unlock position and pulling up to release cover.

  3. The SSL card will need to be installed in one of the two PCI slots. See the empty slot indicated below.

    A close-up view of the PCI slot:

  4. Lift up on the blue tab to remove the PCI slot cover (The blue tab may not detach)

  5. Unpack the SSL board

  6. Insert the board into the PCI slot

    There is no external port for the SSL card:

  7. Replace the Blue tab and the system cover.

    You can now place it back into the datacenter rack and power the system on. No further configuration is necessary on your part.

    WARNING: THE INTERNAL DRIVE INSTALLED IN YOUR SYSTEM MAY DISLODGE WHEN YOU OPEN THE CASE. PLEASE ENSURE THAT IT IS PROPERLY SEATED BEFORE REINSTALLING THE COVER

Published 2017-08-18 20:55